How to · 3 to 4 hours
How to insulate a garage door
Cut rigid foam or a purpose-made kit to fit each panel and hold it in with the retaining clips. It is a straightforward afternoon. The part people miss is that it adds weight — usually fifteen to thirty pounds — and the springs were balanced for the door without it.
Read this first
After insulating, the door will feel heavier and the opener will work harder. The springs need rebalancing by somebody with winding bars — do not try to compensate by winding up the opener force.
What you need
- An insulation kit or rigid foam board
- A utility knife
- A straight edge
- Gloves
5 steps
Doing it
- Measure each panel individually.They are rarely all the same, especially the bottom one.
- Cut each piece about a quarter inch under, so it goes in without bowing the panel.
- Fit the retaining clips or push the foam behind the panel struts.
- Leave the bottom panel's weather seal alone.
- Test the balance: with the opener disconnected, lift the door halfway and let go.A balanced door stays put. If it now sinks or rises, the springs need adjusting before you use the opener again.
Where it stops being yours
Rebalancing the springs is the pro half of this job, and it is not optional.
Advertisement
Exact price
Would rather somebody else did it?
The range above is a guide. Tell us what you need and somebody who works your area will price it properly.
Your details are used to quote this job and nothing else.
More how-to